Template:Device Infobox/ST-506 Controller

Device Infobox/ST-506 Controller

There is no image of this device — upload one!

Bus type	Unknown
Bus width	Unknown
Bus speed	Unknown
8-bit ISA compatible?	Unknown
PCI 5V tolerant?	Unknown
PCI 3.3V tolerant?
Manufacturer	Unknown
Chipset	Unknown
Connectors	Unknown
Requires -5VDC?	Unknown
Requires -12VDC?	Unknown
Config method	Unknown
ST-506 (RLL/MFM) Controller
ST-506 buses	Unknown
ROM type	Unknown
Driver	Missing download URL

This template is used to populate the Device Infobox with information about an ST-506 RLL/MFM controller card. See DTC 7287 for example use. As this template sits inside an infobox, it can be combined with other templates in the case of multi-function devices.

Valid parameters and examples specific to this infobox are:

Parameter	Meaning
ST-506 buses = Value	Number of ST-506 (RLL/MFM) buses that are available on the device. Each bus typically supports the connection of up to two drives. 0 if none 1 if only one bus (up to two drives) 2 for a card with a primary and secondary bus (up to four drives), etc.
ROM type = Value	Text value for the type of ROM/EEPROM/Flash chip. One of: None - no ROM chip is present 28-pin JEDEC - standard byte-wide 28-pin ROM/PROM 32-pin JEDEC - standard 32-pin EEPROM/flash chip PLCC32 - 32-pin PLCC flash chip TSOP40 - 40-pin TSOP package, usually flash memory Add others to this list as needed - try to be as generic as possible, avoiding part names and using interface names instead.

Default values are shown if the parameter is omitted, so do not use any parameters unless the value is known (most of the defaults say "unknown").