Difference between revisions of "Accton EN1640"

From Vogons Wiki
Jump to: navigation, search
(Add resources and screenshots)
(Add driver URL)
Line 14: Line 14:
 
  | Requires -12VDC = Unknown
 
  | Requires -12VDC = Unknown
 
  | Config = [[Config method::Software]]
 
  | Config = [[Config method::Software]]
  | Driver<!-- TODO -->
+
  | Driver = [http://www.vogonsdrivers.com/getfile.php?fileid=900 Vogonsdrivers]
 
}}
 
}}
  

Revision as of 23:20, 4 February 2016

Template:Ethernet Infobox

The Accton EN1640 is a 10Mbps network card.

Additional photos

Boot ROM

This card's boot ROM socket will take a standard 28-pin ROM chip. It has also been successfully tested with a 32-pin ROM chip using an adapter[1]. XTIDE will run without any problem.

The card's DOS drivers come with a configuration program (DIAG/SETUP.EXE) that can be used to enable the ROM socket (it is disabled by default) and set the base address, as well as adjust all the usual options like base address and IRQ.

Resources

  • I/O address: 0, 20, 40, ... 3A0, 3E0, then the same increments starting at 2000, 4000, 6000, 8000, A000, C000, E000.
  • IRQ: 2, 3, 4, 5, 7, 10, 11, 15, Disabled.
  • Boot ROM size: 16kB, 32kB, 64kB, Disabled.
  • Boot ROM: 8000, 8400, 8800, 8C00, then the same increments starting at 9000, A000, B000, C000, D000, E000 and F000.

References

  1. Port 388h - Retrofitting a new EEPROM into an old PC