Biostar IOAT-311: Difference between revisions

Latest revision as of 16:22, 13 February 2016

The IOAT-311 is a generic serial/parallel board.

The pinouts of the serial ports are unknown. This page should be updated when they are found.

@@ Line 1: / Line 1: @@
-{{SuperIO Infobox
+{{Device Infobox/Begin
   | Bus type = ISA
   | Bus width = 8-bit
   | Bus speed = 4.77 MHz
-  | Manufacturer =
+  | Manufacturer = Biostar
   | Chipset = CIC83747AZ
   | Compatible with = [[Has compatibility::RS232]], [[Has compatibility::LPT]]
   | Connectors = [[Has connector::LPT]] <!-- Other connectors aren't shipped with the card so aren't included -->
-  | ROM type = None
+  | Requires -5VDC = No
+ | Requires -12VDC = Yes
+ | Config = [[Config method::Jumpers]]
+}}
+{{Device Infobox/IO
   | Serial ports = 2
+ | UART = 8250 <!-- Assumption based on age -->
+ | COM1 = Yes
+ | COM2 = Yes
+ | COM3 = Yes
+ | COM4 = Yes
   | Parallel ports = 1
+ | Bi-dir = No <!-- Assumption based on age -->
+ | ECP = No
+ | EPP = No
+ | LPT1 = Yes
+ | LPT2 = No
+ | LPT3 = No
+ | LPT4 = No
   | Game ports = 0
- | Floppy buses = 0
+}}
- | Secondary floppy = No
+{{Device Infobox/End
- | IDE buses = 0
- | ST-506 buses = 0
- | Requires -5VDC =
- | Requires -12VDC =
- | Config = [[Config method::Jumpers]]
   | Driver = N/A
 }}
 The '''IOAT-311''' is a generic serial/parallel board.
+The pinouts of the serial ports are unknown.  This page should be updated when they are found.
 == Additional photos ==