Difference between revisions of "Iomega Z100ATAPI"
From Vogons Wiki
Malvineous (Talk | contribs) (Add drive) |
Malvineous (Talk | contribs) (Not 250MB compatible after all) |
||
| Line 3: | Line 3: | ||
| Bus version = PIO-4 <!-- Might be UDMA? --> | | Bus version = PIO-4 <!-- Might be UDMA? --> | ||
| Manufacturer = Iomega | | Manufacturer = Iomega | ||
| − | | Compatible with = [[Has compatibility::ZIP100 | + | | Compatible with = [[Has compatibility::ZIP100]] |
| Connectors = None <!-- Not counting power or the interface connector above, nor jumpers or test points --> | | Connectors = None <!-- Not counting power or the interface connector above, nor jumpers or test points --> | ||
| Requires -5VDC = No | | Requires -5VDC = No | ||
Latest revision as of 09:39, 9 April 2016
Iomega Z100ATAPI
| Bus type | IDE |
|---|---|
| Bus version | PIO-4 |
| Bus width | 16-bit |
| Bus speed | 8.33 MHz (16.66 MB/sec) |
| Manufacturer | Iomega |
| Chipset | Unknown |
| Compatible with | ZIP100 |
| Connectors | None |
| Requires -5VDC? | No |
| Requires -12VDC? | No |
| Floppy Drive | |
| Media type | Zip disk Property "Has media type" has been marked for restricted use. |
| Sides | 2 |
| Tracks | |
| Driver | N/A |
The Iomega Z100ATAPI is an IDE ZIP drive that uses the ATAPI command set, just like CD drives do. This means it requires drivers to be loaded under DOS, however doing so provides better compatibility than native IDE ZIP drives.
Additional photos
Overhead
Rear panel
Series
There are other devices in this series from the same manufacturer.
