Difference between revisions of "Accton EN1640"

From Vogons Wiki
Jump to: navigation, search
(Add underside photo)
(Add boot ROM info)
Line 19: Line 19:
 
Image:Accton EN1640 underside.jpg|Underside
 
Image:Accton EN1640 underside.jpg|Underside
 
</gallery>
 
</gallery>
 +
 +
== Boot ROM ==
 +
 +
This card's boot ROM socket will take a standard 28-pin ROM chip.  It has also been successfully tested with a 32-pin ROM chip using an adapter<ref>[http://sbfmdrv.blogspot.com.au/2015/11/retrofitting-new-eeprom-into-old-pc.html Port 388h - Retrofitting a new EEPROM into an old PC]</ref>.  XTIDE will run without any problem.
 +
 +
The card's DOS drivers come with a configuration program (<tt>DIAG/SETUP.EXE</tt>) that can be used to enable the ROM socket (it is disabled by default) and set the base address, as well as adjust all the usual options like base address and IRQ.
 +
 +
== References ==
 +
 +
<references/>

Revision as of 22:26, 23 January 2016

Template:Ethernet Infobox

The Accton EN1640 is a 10Mbps network card.

Additional photos

Boot ROM

This card's boot ROM socket will take a standard 28-pin ROM chip. It has also been successfully tested with a 32-pin ROM chip using an adapter[1]. XTIDE will run without any problem.

The card's DOS drivers come with a configuration program (DIAG/SETUP.EXE) that can be used to enable the ROM socket (it is disabled by default) and set the base address, as well as adjust all the usual options like base address and IRQ.

References

  1. Port 388h - Retrofitting a new EEPROM into an old PC