https://www.vogonswiki.com/index.php?action=history&feed=atom&title=Trident_PM-V513Trident PM-V513 - Revision history2026-04-29T16:53:21ZRevision history for this page on the wikiMediaWiki 1.30.2https://www.vogonswiki.com/index.php?title=Trident_PM-V513&diff=3107&oldid=prevMalvineous: Document jumpers2016-12-14T12:23:03Z<p>Document jumpers</p>
<p><b>New page</b></p><div>{{Device Infobox/Begin<br />
| Bus type = VLB<br />
| Bus width = 32-bit<br />
| Bus speed = 50 MHz<br />
| Manufacturer = Trident<br />
| Chipset = Trident TGUI9440AGi<br />
| Compatible with = [[Has compatibility::VGA]]<br />
| Connectors = [[Has connector::VGA]]<br />
| Requires -5VDC = No<br />
| Requires -12VDC = No<br />
| Config = [[Config method::None]]<br />
}}<br />
{{Device Infobox/Video<br />
| Max memory = 2 MB<br />
| Max resolution = 1280x1024<br />
| ROM type = 28-pin JEDEC<br />
}}<br />
{{Device Infobox/End<br />
| Driver = N/A<br />
}}<br />
<br />
The '''Trident PM-V513''' is a VESA Local Bus VGA card based around the TGUI9440 chip, released in mid-1993. It has 1 MB of video memory on board, and four sockets to add an additional 1 MB of memory.<br />
<br />
== Additional photos ==<br />
<br />
<gallery mode="packed"><br />
Image:Trident PM-V513 underside.jpg|Underside<br />
</gallery><br />
<br />
== Jumpers ==<br />
<br />
=== J1: VESA bus speed ===<br />
<br />
{|class="wikitable"<br />
! J1 !! Result<br />
|-<br />
| 1-2 || >40MHz operation (slow memory refresh)<br />
|-<br />
| 2-3 || <=40MHz operation (fast memory refresh)<br />
|}<br />
<br />
If this jumper is set incorrectly, the video memory will be refreshed at the wrong speed leading to graphical corruption. The jumper should be set to approximate the bus speed of the motherboard. If the card is set to slow refresh (1-2) and the display is corrupted, changing the jumper to fast refresh should clear the problem. If it does not, the video memory chips are probably damaged.<br />
<br />
Presumably, having this set to a fast refresh when the bus speed is high will either result in corrupted display or a slow down due to the large amount of time wasted refreshing the memory.<br />
<br />
This card has been tested at 40MHz, and at this speed if J1 is set to slow (1-2) then there is some very minor graphical corruption.<br />
<br />
=== JX7: Unknown ===<br />
<br />
The purpose of this jumper is not known. By default it seems to be closed.<br />
<br />
=== J7: Unknown ===<br />
<br />
The purpose of this jumper is not known. By default it seems to be closed. Other boards use J7 to enable/disable interlaced mode.<br />
<br />
== Related links ==<br />
<br />
* FCC ID is [https://fccid.io/HNG920CXRBBS2TLA1 HNG920CXRBBS2TLA1]</div>Malvineous