Template:Device Infobox/PCMCIA Controller

Device Infobox/PCMCIA Controller

There is no image of this device — upload one!

Bus type	Unknown
Bus width	Unknown
Bus speed	Unknown
8-bit ISA compatible?	Unknown
PCI 5V tolerant?	Unknown
PCI 3.3V tolerant?
Manufacturer	Unknown
Chipset	Unknown
Connectors	Unknown
Requires -5VDC?	Unknown
Requires -12VDC?	Unknown
Config method	Unknown
PCMCIA Controller
PCMCIA devices	Unknown
Supports Type I?	Unknown
Supports Type II?	Unknown
Supports Type III?	Unknown
Primary?	Unknown
Secondary?	Unknown
Tertiary?	Unknown
Quaternary?	Unknown
ROM type	Unknown
Driver	Missing download URL

This template is used to populate the Device Infobox with information about a PCMCIA host adapter. See CardSoft PCMCIA Drive for example use. As this template sits inside an infobox, it can be combined with other templates in the case of multi-function devices.

Valid parameters and examples specific to this infobox are:

Parameter	Meaning
PCMCIA devices = Value	Number of PCMCIA devices that can be connected via this host adapter (i.e. the number of card slots it has.) 1 if only one device at a time can be used 2 if two devices can be connected at the same time
TypeI = Value	Boolean value indicating whether this adapter can be used with Type I PCMCIA devices.
TypeII = Value	Boolean value indicating whether this adapter can be used with Type II PCMCIA devices.
TypeIII = Value	Boolean value indicating whether this adapter can be used with Type III PCMCIA devices.
Primary = Value	Boolean value indicating whether this PCMCIA host adapter can be configured on the appropriate I/O ports to operate as the primary adapter in a system.
Secondary = Value	Boolean value indicating whether this PCMCIA host adapter can be configured on the appropriate I/O ports to operate as the second adapter in a system.
Tertiary = Value	Boolean value indicating whether this PCMCIA host adapter can be configured on the appropriate I/O ports to operate as the third adapter in a system.
Quaternary = Value	Boolean value indicating whether this PCMCIA host adapter can be configured on the appropriate I/O ports to operate as the fourth adapter in a system.
ROM type = Value	Text value for the type of ROM/EEPROM/Flash chip. One of: None - no ROM chip is present 28-pin JEDEC - standard byte-wide 28-pin ROM/PROM 32-pin JEDEC - standard 32-pin EEPROM/flash chip PLCC32 - 32-pin PLCC flash chip TSOP40 - 40-pin TSOP package, usually flash memory Add others to this list as needed - try to be as generic as possible, avoiding part names and using interface names instead.

Default values are shown if the parameter is omitted, so do not use any parameters unless the value is known (most of the defaults say "unknown").