Difference between revisions of "FIC 486-GIO-VP"
From Vogons Wiki
Malvineous (Talk | contribs) (Basic info) |
Malvineous (Talk | contribs) (Add power connector) |
||
Line 14: | Line 14: | ||
{{Device Infobox/Motherboard | {{Device Infobox/Motherboard | ||
| Form factor = Baby AT | | Form factor = Baby AT | ||
+ | | Has AT power = Y | ||
+ | | Has ATX power = N | ||
| CPU socket = Socket 3 | | CPU socket = Socket 3 | ||
| ISA slots/8-bit = 0 | | ISA slots/8-bit = 0 |
Revision as of 14:40, 29 January 2017
FIC 486-GIO-VP
There is no image of this device — upload one!
Bus type | VLB |
---|---|
Bus width | 32-bit |
Bus speed | 50 MHz |
Manufacturer | First International Computer, Inc. |
Chipset | VIA VT82C486A |
Compatible with | AT |
Connectors | AT Keyboard |
Requires -5VDC? | Unknown "Unknown" is not recognized as a Boolean (true/false) value. |
Requires -12VDC? | Unknown "Unknown" is not recognized as a Boolean (true/false) value. |
Config method | Jumpers, Software |
Motherboard | |
Form factor | Baby AT |
Power connector | AT |
CPU socket | Socket 3 |
ISA slots | 4 @ 16-bit |
VLB slots | 2 |
RAM slots | 4 @ 30-pin 2 @ 72-pin |
Maximum RAM | 96MB 100,663,296 B |
Boot ROM | Socket, 28-pin JEDEC, read-only |
IDE Controller | |
IDE buses | 1 |
Primary? | Yes |
Secondary? | No |
Tertiary? | No |
Quaternary? | No |
ROM type | None |
Floppy Controller | |
Floppy buses | 1 |
Drives per bus | 2 |
Secondary? | No |
ROM type | None |
IO Controller | |
Serial ports | 2 |
UART | "?" is not in the list (8250, 16450, 16550, 16550A, 16650, 16650V2) of allowed values for the "Has UART" property. |
COM1/2/3/4? | Yes / Yes / No / No |
Parallel ports | 1 |
Bi-dir? | Yes |
ECP? | No |
EPP? | No |
LPT1/2/3/4? | Yes / No / No / No |
Game ports | 0 |
Manual | Vogonsdrivers (PDF) FIC (images) |
Driver | Missing download URL |
The FIC 486-GIO-VP is a 486 VLB motherboard with onboard (VLB) IDE controller. It supports bus speeds of 25, 33, 40 and 50 MHz.
Additional photos
- FIC 486-GIO-VP underside.jpg
Underside
- FIC 486-GIO-VP BIOS.png
CMOS setup
Jumpers
External battery
An external battery can be connected to J13. Pin 1 is positive, pin 4 is negative. The motherboard does not attempt to charge a connected battery, so non-rechargeable batteries can be used.
The manual does not state the battery voltage range, however if the motherboard uses a Dallas DS12885Q RTC chip then the datasheet for this chip specifies the battery voltage must be between 2.5 and 4.0V.