Difference between revisions of "Headland HT12"
Malvineous (Talk | contribs) (Add board) |
Malvineous (Talk | contribs) m (Update manufacturer) |
||
| Line 4: | Line 4: | ||
| Bus speed = 32 MHz | | Bus speed = 32 MHz | ||
| 8-bit ISA compatible = Yes | | 8-bit ISA compatible = Yes | ||
| − | | Manufacturer = | + | | Manufacturer = Headland Technologies <!-- assumed --> |
| − | | Chipset = Headland | + | | Chipset = Headland Technologies HT12 |
| Compatible with = [[Compatible with::AT]] | | Compatible with = [[Compatible with::AT]] | ||
| Connectors = [[Has connector::AT Keyboard]] | | Connectors = [[Has connector::AT Keyboard]] | ||
Revision as of 17:37, 17 April 2016
| Bus type | ISA |
|---|---|
| Bus width | 16-bit |
| Bus speed | 32 MHz |
| 8-bit ISA compatible? | Yes |
| Manufacturer | Headland Technologies |
| Chipset | Headland Technologies HT12 |
| Compatible with | AT |
| Connectors | AT Keyboard |
| Requires -5VDC? | Unknown "Unknown" is not recognized as a Boolean (true/false) value. |
| Requires -12VDC? | Unknown "Unknown" is not recognized as a Boolean (true/false) value. |
| Config method | Jumpers, Software |
| Motherboard | |
| Form factor | Baby AT |
| Power connector | |
| CPU socket | Unknown "Unknown" is not in the list (Socket 5, Socket 7, Socket 8, Slot 1, Socket 370, PLCC68, Socket 3, PGA132, Slot 2, Slot A, ...) of allowed values for the "Has CPU socket" property. |
| ISA slots | 1 @ 8-bit 6 @ 16-bit |
| RAM slots | 4 @ 30-pin |
| Maximum RAM | 4MB 4,194,304 B |
| Boot ROM | Socket, 28-pin JEDEC, read-only |
| Manual | Vogonsdrivers |
| Driver | Vogonsdrivers |
The Headland HT12 is a 286 motherboard capable of up to 16MHz operation, with hardware EMS support.
The manufacturer of this board is currently unknown, so it has been documented here as the Headland HT12.
Additional photos
Underside
- Headland HT12 BIOS.png
CMOS setup (todo)
Memory
Hardware EMS
This motherboard works with the HT12 chipset drivers, which provide an EMS interface allowing a chosen amount of memory above 1MB to be accessed as EMS. Thus it is possible for this board to be configured to have conventional, EMS, XMS and Int15 extended memory available, all at the same time.
UMBs
The chipset does not natively support backfilling unused parts of upper memory with UMBs. However if EMS support is not required, third party drivers can use the hardware EMS facility to make a small amount of memory available in as UMBs.
